Fall manager

NAOqi Motion - Overview | API


What it does

Because the robot may fall, we taught him to stand up. But we went even further by establishing a system to detect falls: it protects with her ​​arms before touching the ground. The robot can therefore fall, he will not hurt.

By default, the fall manager is active on the robot.

How it works

The basic idea is to look at both the support polygon and the Center Of Mass (COM) of the robot. If the COM is detected out of the support polygon, the fall manager process is activated.

This process has priority over all other motion tasks. The chosen strategy is composed by an arms and pelvis joint configuration to protect the robot follow by a stiffness off command to cushion the fall. The joint configuration depends on the fall angle (back, front, right or left).

Memory events called robotIsFalling() and robotHasFallen() are raised when the fall management process starts and finishes, respectively.

Getting started

When the reflex is active

The fall manager reflex is only activated when at least one foot touch the ground (based on ALFsr).

If the robot is lift, sit or other posture than stand, the fall manager is not activated.

How to disable this reflex

As this reflex increases a lot the life time before failure of the robot, we recommend to not disable this reflex.

But as we know that in some situation, this reflex will disturb your work, please follow these two steps to disable it.

Step Action

Allow deactivation

The first step is to allow deactivation of this reflex:

  • with the web page: Consent for the deactivation of safety reflexes, or

  • programmatically:

    The right of deactivation of the fall manager is managed by the ALMotion preference into the robot. (/home/nao/.config/naoqi/ALMotion.xml).

    So, you can edit by hand this file or use the ALPreferenceManager.

    The name of the preferences in ALMotion.xml is: “ENABLE_DEACTIVATION_OF_FALL_MANAGER”.

    And the preference file should have this form:

    <Preference name="ENABLE_DEACTIVATION_OF_FALL_MANAGER" description="If true the
    deactivation of Fall Manager and other critical safety reflexes is allowed"
    value="true" type="bool" />
    

Disable the reflex

Once the deactivation of the fall manager is allowed, it’s possible to use the ALMotionProxy::setFallManagerEnabled() method to disable the fall manager for the current NAOqi launch.

Before this, you should have prepared your own defensive methods to protect from falls.

motionProxy.setFallManagerEnabled(False)

You can also use the ALMotion preference key “ENABLE_FALL_MANAGER_PROTECTION” with a value=”false” for disable at every NAOqi launch the fall manager reflex.

And the preference file should have this form:

<Preference name="ENABLE_FALL_MANAGER_PROTECTION" description="If false the Fall Manager
reflex is disable on this robot." value="false" type="bool" />