SoftBank Robotics documentation What's new in NAOqi 2.5?

Restore my Aldebaran robot user data

1/5 - Making the Aldebaran robot ready for restoration

Step Action

Make sure your robot is in version 2.3 or higher.

For further details, see: Upgrading my NAO.

Check the battery level.

Important: make sure the robot battery is fully charged: a power shortage during restoring could leave the robot in a fatal state.

Tips: if your battery has a limited autonomy, you should leave the charger plugged during the upgrade. However it could be wise to order a new battery.

Make sure you have installed Choregraphe suite.

For further details, see: Choregraphe suite - Installation Guide.

Launch Memory Backup.

2/5 - Select the task to perform

Step Action

Select Restore ....

../_images/memory_backup_retore_step1.png

Warning

This action will replace some data on the robot by the ones present in the backup file. It cannot be reverted.

Click the Next button.

3/5 - Connecting to the Aldebaran robot

Step Action

Select a Aldebaran robot in the list, or type his IP address.

../_images/memory_backup_retore_step2.png

Then click the Next button.

Enter the password of the Aldebaran robot.

../_images/memory_backup_retore_step3.png
Click the Connect button.
Click the Next button.

4/5 - Selecting the file to restore

Step Action

Use the Browse button to select the backup file to restore on the robot.

../_images/memory_backup_retore_step4.png
Then click the Next button.

5/5 - Finalize the restoration

Step Action

Read it carefully and then click the Restore button.

../_images/memory_backup_retore_step5.png

Note

You will not be able to pursue if the robot is not plugged.

Once the restoration is done, click the Finish button.

See also Backup/Restore robot data troubleshooting.