SoftBank Robotics documentation What's new in NAOqi 2.5?

Replacing the battery

See also

Charging the battery

If your battery needs to be replaced:

Step Action
Make sure you have a Phillips 0 screwdriver.
Read the Safety guidelines.

Disconnect the power cable from the plug located on NAO‘s back.

../_images/disconnect.png

Remove the screws of the battery cover with the Phillips 0 screwdriver (2 screws on NAO V4, 4 screws on NAO V3.x).

../_images/vis_dos_v3_v4.png

Remove the used battery and replace it with a new one.

../_images/hardware_battery.jpg
Once it fits snuggly in its slot, place the cover back into position and tighten all screws.

Charge your new battery.

For further details, see Charging the battery.